3.7V 3000mAh Lithium LIPO Battery Nodemcu ESP32 Develop Board Micro JST 1.25Plug

3.7V 3000mAh Lithium LIPO Battery Nodemcu ESP32 Develop Board Micro JST 1.25Plug

3.7V 3000mAh Lithium LIPO Battery Nodemcu ESP32 Develop Board Micro JST 1.25Plug
3000mAh: The recommended charging current is 0.6A, the maximum does not exceed 3A. The discharge current is recommended 1.5A, and the maximum does not exceed 3A Over-discharge protection: When the battery is about to run out and the voltage is as low as 3.0V, the protection board will also be turned off and can no longer be discharged, forming an over-discharge protection effect Overcharge protection: When charging the battery, when the voltage reaches the highest battery voltage (4.2V), the protection board will automatically power off and shut down, indicating that it will not continue to charge when fully charged. 3.7V 3000mAh Lithium LIPO Battery Nodemcu ESP32 Develop Board Micro JST 1.25Plug. MakerFocus 4pcs 3.7V 3000mAh Lithium Rechargeable Battery 1S 1C Lipo Battery with Protection Board Insulated Rubber Tape and Micro JST 1.25 Plug for Ar duino NodeMCU ESP32 Development Board. Note: The battery overcurrent protection is not a panacea, do not continue to charge and discharge the current and voltage with a large current beyond the range, otherwise the protection board will be damaged and invalid.

The discharge current is recommended 1.5A, and the maximum does not exceed 3A. Over-discharge protection: When the battery is about to run out and the voltage is as low as 3.0V, the protection board will also be turned off and can no longer be discharged, forming an over-discharge protection effect. Overcharge protection: When charging the battery, when the voltage reaches the highest battery voltage (4.2V), the protection board will automatically power off and shut down, indicating that it will not continue to charge when fully charged.

Short circuit protection: When an accidental short circuit occurs, the protection board will automatically shut down within a few milliseconds and will not be powered on again. Note that the cell is short-circuited (not through the protection board). The protection board will also fail due to continuous high current, or the components are heated and damaged. The maximum operating current of this battery is only about 1.5A, can not be used for unmanned aerial vehicles, model aircraft or power tools and other products that require high current 2.

Connector is Micro JST 1.25 plug, it can be used for ESP32 Ar duino development board whose plug is 1.25mm Specification: Standard Voltage: 3.7V Capacity: 3000mAh Approx Weight : 35g Dimensions(±2mm): 50 34 10 mm /1.96 1.33 0.39inch(LWH) Discharge Rate: 1C Working Current: 1.5A The maximum discharging current: 3C Overcurrent Protection: 1.8-2.1A Type of Connector: Micro JST 1.25. We stand behind every product we sell. Thanks for your trust and understanding in advance. Hope you have a good shopping experience in my store.

Thank you so much for your support!


3.7V 3000mAh Lithium LIPO Battery Nodemcu ESP32 Develop Board Micro JST 1.25Plug


Lipo Battery Mah    Sitemap    Contact Us    Privacy Policy Agreement    Terms of Use